Skip to content

Free C-15: Flooring practice test

  • 15 questions
  • ~8 minutes
  • Scored instantly

15 questions from the Peerless Institute C-15: Flooring exam, including five questions about one diagram. The C-15: Flooring exam covers the following topics:

  • Planning and Estimating21%
  • Subfloor Evaluation, Preparation, and Material Acclimation20%
  • Carpet Installation12%
  • Resilient and Rubber Flooring Installation12%
  • Laminate Flooring Installation8%
  • Wood Flooring Installation10%
  • Concrete Treatment and Synthetic Application4%
  • Safety13%

Percentages are approximate, per the CSLB examination content outline.

Study materials for this exam

0 of 15 answered
  1. 1Which of the following best defines the grade that is mostly intended as a trimming grade, but shall be of such quality that a sound floor is obtainable from at least 98 percent of the flooring units in the shipment or order?

  2. 2The general rule for estimating hardwood flooring is the square feet required plus 5 percent for cutting and split lumber. Which of the following conditions would not allow this general rule to work?

  3. 3Metal ladders should be at least ___ feet from 220 volt electrical wiring.

  4. 4The blueprints show a brick exterior finish, therefore, the contractor can not select the least expensive brick he can buy because:

  5. 5When pneumatic nailers and staplers are in use, all personnel, except tool operators, may not come within how many feet of the area?

  6. 6According to the American Parquet Association, a contractor who installs either 9" x 9" or 12" x 12" or 19" x 19" meshback-adhesive parquet panels onto a subfloor, that needs no preparation except sweeping, can in a conservative estimat ft. in an 8 hour day.

  7. 7Allowing 12 percent waste, how much carpet would have to be purchased if the carpet comes in 12 foot wide rolls for the living room, 2 bedrooms and 3 closets?

  8. 8How much money will settle a bill for $800.00 less 20 percent, 15 percent and 5 percent?

  9. 9The employee, if he is going to file a claim for loss of wages due him because he was laid off or discharged for refusing to work under a safety violation, must notify his employer within ____ days that he filed a claim with the Labor Commissioner & then file within 30 days.

  10. 10The list price on a lot of bricks was $2872.00 less discounts of 17 percent, 15 percent and 10 percent what was the net price?

Diagram practice

Use this diagram to answer the next five questions. Use the stated exercise data; the drawing is not to scale.

Three plank rows alternate two seam coordinates from one datum.
Plank layout and end-joint phase · Open full-size diagram in a new tab
Diagram text description

Three plank rows alternate two seam coordinates from one datum. PEERLESS / FLOORING AND FLOOR COVERING C15-DX-01 Plank layout and end-joint phase R1 R2 R3 R1/R3: 1,200 mm R2: 600 mm PROJECT DETAIL Plank layout geometry. Common left datum. Row 1 seam at 1,200 mm. Row 2 seam at 600 mm. Row 3 seam at 1,200 mm. No minimum end-joint stagger limit asserted. Diagram interpretation exercise • Not a construction document • Not to scale R1 and R3 each contain two planks with a shared seam coordinate 1,200 mm from the left datum. R2 contains three planks; its left seam coordinate is labeled 600 mm.

  1. 11What offset lies between Row 1 and Row 2 marked seams?

  2. 12Which rows have aligned marked end joints?

  3. 13If Row 3 start shifts 300 mm right with its joint pattern unchanged, where is its marked seam?

  4. 14If only Row 2’s marked seam shifts 300 mm right, what offset remains between that seam and Row 1’s marked seam?

  5. 15Which marked seam is closest to the common left datum?