Skip to content

Free C-17: Glazing practice test

  • 15 questions
  • ~8 minutes
  • Scored instantly

15 questions from the Peerless Institute C-17: Glazing exam, including five questions about one diagram. The C-17: Glazing exam covers the following topics:

  • Planning and Estimating27%
  • Fabrication and Installation of Framing Systems21%
  • Fabrication and Installation of Glazing Materials18%
  • Glazing Replacement and Retrofit Projects15%
  • Safety19%

Percentages are approximate, per the CSLB examination content outline.

Study materials for this exam

0 of 15 answered
  1. 1Mirrors over ten square feet that are mounted with screws or rosettes must have holes drilled in them that are at least 1/8 inch wider than the screws and at least _________ inches from the mirror’s edge.

  2. 2Light-transmitting plastics shall not be installed more than 75 feet above grade plane.

  3. 3If you use a double-faced tape to fasten a mirror to the wall, the tape should be at least 1/8 inch thick and:

  4. 4If someone is hurt and the contractor does not have Worker’s Compensation, the contractor: compensation plus a 10% penalty.

  5. 5Caulking should not be done unless the temperature is at least :

  6. 6When cutting notches with 900 inside corners in glass, you should: between the holes.

  7. 7When pneumatic nailers and staplers are in use, all personnel, except tool operators, may not come within how many feet of the area?

  8. 8If a joint is 1” wide at the time of sealant installation, the joint must not be extended more than 3/4” for a sealant that has movement capability of:

  9. 9Fixed glazing greater than 9 sq. ft. with the lowest exposed edge less than 18” and the top edge greater than 36” above finished floor and walking surface within 36” need not have safety glazing provided: 38” above the floor.

  10. 10A plumber bought pipe amounting to $425.00. He sold this pipe at a loss of 8-1/2%. How much was his loss?

Diagram practice

Use this diagram to answer the next five questions. Use the stated exercise data; the drawing is not to scale.

Storefront sill pocket with water route to a sealant-blocked exterior weep.
Storefront sill drainage and blocked weep · Open full-size diagram in a new tab
Diagram text description

Storefront sill pocket with water route to a sealant-blocked exterior weep. Storefront sill drainage and blocked weep Storefront sill drainage section • Dimensions and states shown govern this exercise • Not to scale Glass Water to weep X Exterior X = sealant covering system drainage opening. EXERCISE BASIS Drainage concept only; actual storefront system details govern. The sill-pocket outline has a horizontal base. A blue Water to weep arrow slopes down-right into X at the exterior drainage opening. A separate arrow continues right toward Exterior. X is labeled sealant covering the drainage opening.

  1. 11Which marker blocks the intended drainage route?

  2. 12Which direction should collected water leave?

  3. 13What should be checked before sealing a sill opening?

  4. 14What material is identified as covering the system drainage opening at X?

  5. 15Does the downward-right water arrow establish the physical slope of the sill-pocket base?